The miniNG is the first fan controller with the patented Dual mode technology (DMT). This technology combines the smoothness of an analogue controller with the power of a PWM controller. The user may now choose between analogue control and PWM mode as desired, and that on-the-fly and, if the miniNG is connected through a T-Balancer, even via Software!

The miniNG is a 2-channel fan controller with 2 temperature sensors. It is equipped with a very large cooling block  to allow continuous operation even under high loads in both analogue and PWM mode to allow the use of even very powerful fans and pumps. The maximum power output per channel is 20W in analogue mode and 50W in PWM mode.

The miniNG is also the first controller which works perfectly with the Laing DDC-12V pump.

The configuration is quick and easy: In standalone mode with jumper and potentiometers or via Software with the T-Balancer. The following modes are pre-set: Target temperature control, steps, curve and manual. These modes can be set with the help of the potentiometers. The T-Balancer also allows configuration of the modes and the uploading of custom curves.

Features:

• Small dimensions - huge array of features
• Separate control of 2 fan channels
• 50W power per channel in PWM mode, combined 100W
• 20W power per channel in analogue mode, combined 25W
• 2 analogue temperature sensors
• Initial starting mode for pumps (8 seconds)
• Configuration via Jumper and potentiometers in standalone mode
• Free configuration with software via a T-Balancer
• Integrated overheating protection in analogue mode

The heart of the miniNG is a high-grade microprocessor with integrated permanent memory. The processor allows a wide array of configurations and connection with the T-Balancer. The permanent memory saves all settings and allows loading of the settings when starting, independently from the operating system or BIOS!

The miniNG works completely autarkic and can be operated without a T-Balancer. But if a T-Balancer is available the miniNG can be connected via a sensor bus and freely configure it via Software. The suitable software can be found here. Amongst others Everest 4.60 supports the miniNG and bigNG.

Technical details:
Dimensions: 60x50x16mm
Weight: approx. 95g
Maximum power draw: 10A
Overall maximum power: 100W (PWM)/ 25W (analogue)

Extent of delivery:
2 thin analogue foil sensors
Jumper
sensor cable for connection with a T-Balancer
Installation material

Please note: The users manual can be downloaded here